产品型号:sc4060
产品描述:太阳能控制器实时采集电池充电电流、放电电流、电池电压、电池温度、充电时间、放电时间等电池运行数据,利用蓄电池的充放电特性,采用的计算方法,实现对电池充放电过程中任一状态下剩余容量的动态测量。通过精确地控制蓄电池组的充电过程,能够帮助用户延长蓄电池的使用寿命,大限度发挥蓄电池的性能,此款控制器采用铝合金机壳,坚固耐用。
功能特点:
◆ mpu控制;
◆ 液晶屏显示;
◆ 存储累计充电安时数;
◆ 存储累计放电安时数;
◆ 电池停充电压hvd可设置;
◆ 电池停放电压lvd可设置;
◆ 负载开机恢复电压lvr可设置;
◆ 智能化温度补偿;
◆ 过载保护;
◆ 短路保护;
◆ 反向放电保护;
◆ 极性反接保护;
◆ 雷电保护;
◆ 欠压保护;
◆ 过充保护;
技术参数:
规格
sc4060/40a
sc4060/50a
sc4060/60a
额定电压
48v
大负载电流
≤40a
≤50a
≤60a
大充电电流
≤40a
≤50a
≤60a
充满断开(hvd)
54.8v默认值,可设置
欠压断开(lvd)
43.2v默认值,可设置
过放恢复(lvr)
50.4v
温度补偿
-3mv/℃/cell
空载损耗
≤25ma
大电线规格
10mm2
回路压降
<200mv
<240mv
<270mv
重量
1.5kg
尺寸
210mm*150mm*65mm(长*宽*高)
苏尔电子产品安装调测流程说明:
接线方法 wiring methods
本公司生产的太阳能充电控制器总共有六个接线孔,从左到右分别接,(1)太阳能板正极 ,(2)太阳能板负极,(3)蓄电池正极,(4)蓄电池负极,(5)负载正极,(6)负载负极。在接线之前,请确认太阳能板输出电压,电池电压,负载输入电压三者一致。
this controller has six wiring terminals, address controller, from left to right are ";(1) solar panels+, (2) solar panels -, (3) battery+ , (4) battery -, (5) load + and (6) load -. "; please be sure before wiring solar panels, battery and load voltage is the same.
接线步骤wiring:
首先接上蓄电池the first step to battery:
将电池的正极和负极相应的接入控制器的第三个和第四个接线孔,接入后,控制器的“battery”显示灯会亮,代表蓄电池连接正确。否则请检查蓄电池是否接入正确。在进行下一步接线步骤之前应确保蓄电池连接正常。
battery cathode and anode, respectively access controller ";(3) batteries +"; and ";(4) battery -"; not received the attention of opposing controller otherwise unable to work, (then controller observed the ";battery"; light ";battery ";light-liang said that the correct wiring, or to check the battery and wiring, until right before the first step to the next step.
其次接上太阳能板solar panels to the second step:
将太阳能板的正极和负极相应接入控制器的个和第二个接线孔,禁止反接,接入时不必担心电池反充。
solar panels and the cathode to anode, respectively controller ";(1) solar panels +"; and ";(2) solar panels -"; not to pay attention to the anti-will not be able to recharge.
后接负载the third step to load:
将负载电器的正极和负极相应接入控制器的第五和第六个接线孔,特别注意,禁止反接,禁止短路。否则会损坏负载电器。
load the cathode and anode, respectively access controller ";(5) load +"; and ";(6) load -"; wired attention - not to, otherwise you could damage the load (in electrical).
接好线后,系统可以通电使用。
after wiring, or put into use.
产品用途 : 太阳能系统的充放电控制 ;
名称 : 太阳能控制器 ;
详细介绍
武汉苏尔电子科技有限公司其他商品